Zugriff
- Zugriff über Telnet auf Port 23
Konfigurations-Menü
Zugriff auf die Konsole
enable
- 5510-24T>enable
- 5510-24T#
show-Befehle
running-config
5510-24T#show running-config
! Embedded ASCII Configuration Generator Script
! Model = Ethernet Routing Switch 5510-24T
! Software version = v6.2.0.008
!
! Displaying only parameters different to default
!================================================
enable
configure terminal
...
...
...
interfaces
Status Auto Flow
Port Trunk Admin Oper Link LinkTrap Negotiation Speed Duplex Control
---- ----- ------- ---- ---- -------- ----------- -------- ------ -------
1 Enable Down Down Enabled Enabled
2 Enable Down Down Enabled Enabled
3 Enable Down Down Enabled Enabled
4 Enable Down Down Enabled Enabled
5 Enable Down Down Enabled Enabled
...
...
...
vlan
Id Name Type Protocol PID Active IVL/SVL Mgmt
--- -------------------- -------- ---------------- -------- ------ ------- ----
1 VLAN #1 Port None 0x0000 Yes IVL Yes
Port Members: 1-6
2 VLAN #2 Port None 0x0000 Yes IVL No
Port Members: 7-12
ip route
===============================================================================
Ip Route
===============================================================================
DST MASK NEXT COST VLAN PORT PROT TYPE PRF
-------------------------------------------------------------------------------
Total Routes: 0
-------------------------------------------------------------------------------
TYPE Legend:
I=Indirect Route, D=Direct Route, A=Alternative Route, B=Best Route, E=Ecmp Rou
te, U=Unresolved Route, N=Not in HW
Konfigurieren
- 5510-24T#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
5510-24T(config)#
Allgemeine Konfiguration (IP, Netmask, Gateway)
- ip address switch x.x.x.x netmask y.y.y.y default-gateway z.z.z.z